When rain falls to the ground, the water does not stop moving. Some of it flows along the land surface to streams or lakes, some is used by plants, some evaporates and returns to the atmosphere, and some seeps into the ground. Water seeps into the ground much like a glass of water poured onto a pile of sand.
As water seeps into the ground, some of it clings to particles of soil or to roots of plants just below the land surface. This moisture provides plants with the water they need to grow. Water not used by plants moves deeper into the ground. The water moves downward through empty spaces or cracks in the soil, sand, or rocks until it reaches a layer of rock through which water cannot easily move. The water then fills the empty spaces and cracks above that layer. The top of the water in the soil, sand, or rocks is called the water table and the water that fills the empty spaces and cracks is called ground water.
Water seeping down from the land surface adds to the ground water and is called recharge water. Ground water is recharged from rain water and snowmelt or from water that leaks through the bottom of some lakes and rivers. Ground water also can be recharged when water-supply systems (pipelines and canals) leak and when crops are irrigated with more water than the plants can use.
At least some ground water can be found almost everywhere. The water table may be deep, such as under a hillside, or shallow such as under a valley. The water table may rise or fall depending on several factors. Heavy rains or melting snow may increase recharge and cause the water table to rise. An extended period of dry weather may decrease recharge and cause the water table to fall.
Who uses ground water?
More than 50 percent of the people in the United States, including almost everyone who lives in rural areas, use ground water for drinking and other household uses. Ground water is also used in some way by about 75 percent of cities and by many factories. The largest use of ground water is to irrigate crops.
How do you get water out of the ground?
Ground water can be obtained by drilling or digging wells. A well is usually a pipe in the ground that fills the ground water. This water can then be brought to the land surface by a pump. Shallow wells may go dry if the water table falls below the bottom of the well, as illustrated at right.
Water leaving an aquifer is called discharge water. Water that is pumped from a well is discharge water. Ground water might also discharge naturally as springs or into swamps, lakes, or rivers.
Some wells, called artesian wells, do not need a pump. These wells are drilled into an artesian aquifer, which is sandwiched between two impermeable layers. Water enters an artesian aquifer in a permeable recharge zone, which can be miles away from the well. When a well is drilled into an artesian aquifer, pressure pushes water in the well above the top of the aquifer. If the pressure is high enough, water can flow from an artesian well.
Illustration showing how a artesian well flows.
Can we run out of ground water?
We can run out of ground water if more water is discharged than recharged. For example, during periods of dry weather, recharge to the aquifers decreases. If too much ground water is pumped during these times, the water table can fall and wells may go dry.
Ground water can become unusable if it becomes polluted and is no longer safe to drink. In areas where the material above the aquifer is permeable, pollutants can seep into ground water. Ground water can be polluted by seepage through landfills, from septic tanks, from leaky underground fuel tanks, and sometimes from fertilizers or pesticides used on farms as shown at right.
No comments:
Post a Comment